Published by Radius Networks on 2017-03-10
1. In order to re-enter configurable mode for a RadBeacon Tag, remove the front cover and press the configuration push button switch near the coin cell battery.
2. In order to re-enter configurable mode for a RadBeacon X2, remove the front cover and switch the beacon power switch to OFF and back to ON.
3. Change any of the modifiable settings and select the Apply button to submit a valid PIN to update the settings for this beacon.
4. Select the Lock button to submit a valid PIN to prevent connections from remote Bluetooth 4.0 devices to the beacon configuration service.
5. In order to re-enter configurable mode for a RadBeacon USB, remove and restore power to the device.
6. Select the DFU button to reboot the beacon into Direct Firmware Update mode.
7. The RadBeacon™ app is the configuration utility for RadBeacon proximity beacons from Radius Networks that support Apple's iBeacon™ proximity services as well as other emerging proximity services.
8. Select the Update PIN button to submit a new and existing PIN to update the PIN for your beacon.
9. Select the Reset button to reset the device to the original factory settings.
10. A beacon set in configurable mode will be configurable for up to 30 minutes or until you lock the device again.
11. Submit a valid PIN to reset the settings for your beacon to factory defaults.
12. Liked RadBeacon? here are 5 Utilities apps like My Verizon; myAT&T; T-Mobile; My Spectrum; Calculator & Math Solver;
Or follow the guide below to use on PC:
Select Windows version:
Install RadBeacon app on your Windows in 4 steps below:
Download a Compatible APK for PC
| Download | Developer | Rating | Current version |
|---|---|---|---|
| Get APK for PC → | Radius Networks | 1 | 2.5 |
For Windows 11, check if there's a native RadBeacon Windows app here » ». If none, follow the steps below:
| Minimum requirements | Recommended |
|---|---|
|
|
Download on Android: Download Android
PC Apps 
