iHandy Carpenter for Pc

1. Put one edge or back of your iPhone stick to the inclined surface (The edge of iPhone should be in line with the slope direction of the surface).

2. Put your iPhone onto the inclined surface (The edge of iPhone should be in line with the slope direction of the surface.

3. - Once calibrated, the plumb bob, surface level and level bar can also be used as an inclinometer/clinometer by reading the angles on the screen.

4. If the shadow of the plumb bob is on the X-axis (y equals zero), it then indicates your wall is perfectly straight and vertical to the ground.

5. If the shadow of the plumb bob is on the Y-axis (x equals zero), it then indicates your wall is perfectly straight and vertical to the ground.

6. The reading of "x" is the slope angle of the measured surface.

7. Put one edge of your iPhone on the wall you measure.

8. Put your iPhone back-to-back onto the wall you measure (Recommended).

9. But it's accurate enough just to use the flat part of your iPhone.

10. Please note that in this way the reading of "X" does NOT have to be zero.

11. The back of iPhone is not totally flat due to the camera bump.

12. Liked iHandy Carpenter? here are 5 Utilities apps like Carpenter Calculator Pro; PROtractor – the angle tool for every carpenter, joiner und craftsman; Prime Builder Calculator - Measurement & Converter Tool for Handyman, Engineer, Carpenter; Carpenter Tools - Post Spacing Calculator;