Uilleann PC 용

다운로드 Uilleann PC 용

에 의해 게시 Michael Eskin

  • 출시일: 2018-07-27
  • 카테고리: Music
  • 다운로드: $4.99
  • 현재 버전: 8.7
  • 파일 크기: 43.35 MB
  • 호환성: Windows 11/Windows 10/8/7/Vista

다운로드 ⇩
평점:

4.0/5
4
보낸 사람 5 평점

★ ★ ★ 에디터의 리뷰

1. To play the chanter, touch the three holes of the left side of the chanter starting with the tips of your left index, middle, and ring fingers.

2. Touch the MIDI icon on the lower left corner to set the MIDI channels and lowest note for your MIDI chanter (55 to 79).

3. Uilleann is an extremely authentic sounding Full Set of Traditional Irish Bagpipes that may be played like the real instrument on screen or with a hardware MIDI chanter.

4. Touch the red "Stop" bar at the bottom right center with your right thumb to stop the chanter sound while closing all the holes for traditional staccato closed piping techniques.

5. Optional pitch bending of the chanter notes is done by first turning on "Note Bending" in the controls, then sliding the finger up or down very slightly on the root tone hole for the note.

6. Touch the blue "Back-D" bar at the bottom left center with your left thumb to play the second octave "Back-D" on either a press or release based on the setting of the "Back-D Mode" control.

7. Next, touch the four holes on the right side of the chanter with the tips of your right index, middle, ring, and little fingers.

8. You may also perform finger vibrato on the chanter for most notes with the right middle and/or ring fingers.

9. Regulator pairs respond on the next MIDI channel after the chanter starting on MIDI note 60.

10. Touch the green "Octave" bar on the left side with your left little finger to play the notes one octave higher.

11. The app responds to MIDI Pitch Bend messages (two-semitone range) on the Chanter channel.



스크린 샷



다운로드 및 설치 방법 Uilleann - Irish Bagpipes 귀하의 PC 및 Mac에서


호환되는 PC 앱 또는 대안 확인


다운로드 평점 개발자
Uilleann 앱 또는 대안 다운로드 ↲ 5
4.00
Michael Eskin

또는 아래 가이드를 따라 PC에서 사용하십시오. :



PC 버전 선택:

  1. Windows 10
  2. Windows 11

소프트웨어 설치 요구 사항:

1 단계 : PC 및 Mac 용 Android 에뮬레이터 다운로드

직접 다운로드 가능합니다. 아래 다운로드 :

  1. Nox »
  2. Bluestacks »

2 단계 : PC 또는 Mac에 에뮬레이터 설치


3 단계 : Uilleann - Irish Bagpipes PC의 경우 - Windows 7/8 / 10 / 11

설치 한 에뮬레이터 애플리케이션을 열고 검색 창을 찾으십시오. 일단 찾았 으면 Uilleann - Irish Bagpipes 검색 막대에서 검색을 누릅니다. 클릭 Uilleann - Irish Bagpipes응용 프로그램 아이콘. 의 창 Uilleann - Irish Bagpipes Play 스토어 또는 앱 스토어의 스토어가 열리면 에뮬레이터 애플리케이션에 스토어가 표시됩니다. Install 버튼을 누르면 iPhone 또는 Android 기기 에서처럼 애플리케이션이 다운로드되기 시작합니다. 이제 우리는 모두 끝났습니다.
"모든 앱 "아이콘이 표시됩니다.
클릭하면 설치된 모든 응용 프로그램이 포함 된 페이지로 이동합니다.
당신은 아이콘을 클릭하십시오. 그것을 클릭하고 응용 프로그램 사용을 시작하십시오.


PC 용 호환 APK 받기


다운로드 개발자 평점 현재 버전
다운로드 PC 용 APK » Michael Eskin 4.00 8.7


다운로드 Uilleann Mac OS의 경우 (Apple)

다운로드 개발자 리뷰 평점
$4.99 Mac OS의 경우 Michael Eskin 5 4.00

Windows 11용으로 가져오기


PC를 설정하고 Windows 11에서 Uilleann 앱을 다운로드하는 단계:

  1. 컴퓨터가 호환되는지 확인: 최소 요구 사항은 다음과 같습니다.
    • RAM: 8GB (최저한의), 16GB (추천)
    • 저장: SSD
    • Processor:
      • Intel Core i3 8th Gen (최소 이상)
      • AMD Ryzen 3000 (최소 이상)
      • Qualcomm Snapdragon 8c (최소 이상)
    • Processor Architecture: x64 or ARM64
  2. Uilleann - Irish Bagpipes 에 이미 기본 Windows 버전이 있는지 확인하십시오. 여기서 하세요 ». 기본 버전이 없으면 3단계로 진행합니다.
더 읽기 » »


기능 및 설명

Uilleann is an extremely authentic sounding Full Set of Traditional Irish Bagpipes that may be played like the real instrument on screen or with a hardware MIDI chanter. The app emulates the chanter, three drones, and regulators of a full set of Uilleann pipes. It plays in all the traditional keys of D, C#, C, B, and Bb, and is fully tuneable as much as +/- 50 cents. The Uilleann pipes are a bellows driven set of bagpipes with a two octave range. The chanter fingerings are based on those used for the Uilleann pipes and will also be familiar and intuitive for players of the tin whistle and Irish flute. The app supports traditional finger vibrato, and note bending effects. MIDI Chanter Setup: Connect your MIDI chanter first using a hardware MIDI interface, then launch the app. Touch the MIDI icon on the lower left corner to set the MIDI channels and lowest note for your MIDI chanter (55 to 79). MIDI default parameter values are based on the Fagerstrom Uilleann Technopipes: Drone channel: 15 Chanter channel: 1 Lowest Note: 69 The app responds to MIDI Pitch Bend messages (two-semitone range) on the Chanter channel. The Note Bending control enables/disables the feature. Regulator pairs respond on the next MIDI channel after the chanter starting on MIDI note 60. MIDI settings are saved on exit. How to Play: IMPORTANT: Since this app requires as many as 9 fingers on the screen at the same time, before playing, disable "Multitasking Gestures" on your iPad (in the Settings app, under the General section, turn the Multitasking Gestures switch to the off position). Touch the 'i' icon at the upper right corner of the main screen to show/hide the controls. Touch the '?' on the upper left corner to show/hide the on-screen help labels. Select your instrument key from the key selector and adjust the fine tuning with the tuning slider. The number to the left of the tuning shows shows the tuning offset in cents. To reset the tuning to zero, just touch the number. Touch the drone puck to start/stop the drones. To play the chanter, touch the three holes of the left side of the chanter starting with the tips of your left index, middle, and ring fingers. Next, touch the four holes on the right side of the chanter with the tips of your right index, middle, ring, and little fingers. Touch the green "Octave" bar on the left side with your left little finger to play the notes one octave higher. The regulators are played with the right thumb on the circles between the right side of the chanter and the bottom control bars. Use the TB/BB select to choose between Tenor+Baritone or Baritone+Bass regulator pair chords The chords in TB mode are as they would be on the real instrument: D, G, D, G, and A In BB mode they are None (to align with the TB chords), G, D, G, and A Use the Regulator Volume slider to set the balance of the regulators against the chanter and drones. The regulators use the same Reverb Send setting as the chanter. Optional pitch bending of the chanter notes is done by first turning on "Note Bending" in the controls, then sliding the finger up or down very slightly on the root tone hole for the note. Touch the blue "Back-D" bar at the bottom left center with your left thumb to play the second octave "Back-D" on either a press or release based on the setting of the "Back-D Mode" control. Touch the red "Stop" bar at the bottom right center with your right thumb to stop the chanter sound while closing all the holes for traditional staccato closed piping techniques. It represents the bottom of the chanter that is closed with the leg. Touch the purple "Bend" bar on the lower right with your right little finger to bend the pitch or play finger vibrato. You may also perform finger vibrato on the chanter for most notes with the right middle and/or ring fingers. Chanter image based on my Kirk Lynch concert pitch chanter. Drone puck image courtesy of Mike DeSmidt. Crowley drone sample courtesy of Vinnie Kilduff.



추가 응용 프로그램 Michael Eskin





최고의 앱 - Music